Diezel Herbert Manual de usuario

User Manual for the Diezel Herbert Amplifier

3.2.3 Switch-able Loop as additional Volume Control Those of you who can live without processors in the parallel loop can use this loop for a seco

3.2.7 Compensated Out A frequency corrected signal will leave this jack if you connect it to a mixer or recording device. Use it to quietly compos

3.3 MIDI Connections 3.3.1 MIDI In Midi in receives “program change” orders from commonly available midi pedals and control systems. The Herbe

Chapter Four: Three Pre-Amplifiers 4.1 Pre-Amplifiers and their Functions The Diezel Herbert comes equipped with 3 different and totally inde

4.1.4 Mid Cut The section Mid Cut incorporates controls for Intensity and Level. Designed for friends of Heavy or Nu-Metal type musical styles, th

4.3 Microphonics and Bad Noises The overall performance of pre-amp tubes is easily influenced by mechanical factors from the outside. This would m

Chapter Five: Power Amplifier 5.1 Tone and Volume of the Power Amplifier 5.1.1 Master Volume As the name suggests, this controls the overa

5.2 Power Amplifier Tubes 5.2.1 Function As the name suggests, the power amp section is the part of the amplifier that produces output power,

Chapter Six: Functions and Switches 6.1 Programming the Herbert It is quite easy to program your Diezel Herbert and, also, easy to explain.

6.3 Mid Cut On/Off The switching function “Mid Cut” is applicable to all channels. The Mid Cut is active when the corresponding LED is lit. 6.

Table of Contents Chapter One: Safety and Warranty 1.1 Safety Warnings 1.2 Warranty Information Chapter Two: Using Your Herbert

Chapter Seven: MIDI 7.1 MIDI MIDI is an acronym for Musical Instruments Digital Interface and is an internationally accepted communications sy

7.4.2 Single Channel Mode – Automatic Channel Recognition Your Herbert can automatically recognize the pedal’s send/receive channel. To get your a

Chapter Eight: Footswitch The optional Columbus footswitch can be connected via the rear panel mounted XLR jack. The Columbus will not recognize f

9.3 Tube Change Tube changes are only to be undertaken by authorized service personnel. If power tubes with different values then the original one

Chapter Five: Power Amplifier 5.1 Tone and Volume of the Power Amplifier 5.1.1 Master Volume 5.1.2 Presence 5.1.3 Deep 5.2 Pow

Chapter One: Safety and Warranty 1.1 Safety Warnings We would like to stress the importance of the following points, for reasons of your pers

1.2 Warranty 5 years to the original owner with proof of purchase. Power Tubes and Pre Amp tubes are covered for 3 months to the original owner. T

Chapter Two: Using Your Herbert 2.1 Mains Connections, Power and Standby 2.1.1 Mains/Connection to Power Outlet Please make sure that both

2.1.4 Operating Temperature It will take a little more time after warm-up until everything inside the amp is working in sync and to it’s fullest p

Chapter Three: Peripheral Connections 3.1 Front Panel Connections 3.1.1 The input jack (“IN”) The input jack receives your Electric Guitar si

3.2 Rear Panel Connections 3.2.1 Send/Return Loop The System consists of 3 separate Loops. It allows creation of effects path in either serial